Photo of the cabin top with the tools of the trade. After a thorough cleaning inside and out, I've been "countersinking" all the holes left after removing all the deck hardware. This is to give a "scarf" for my epoxy resin plugs to adhere too.
Viewed: 628 times.
|
| Lots and lots and lots of holes. Over a hundred. Some were present and badly plugged from equipment that was no longer mounted.
Viewed: 559 times.
|
| A close up of the holes used to deck mount my halyard winches. I'm almost certainly going to relocate these somewhere else. They prevented me from opening my cabin hatch cover.
Viewed: 528 times.
|
|
Picture of the stern looking forward and the "structure" I need to remove to allow my outboard motor to tilt up out of the water. The motor head is too big and hits the white barrier in the back of the cockpit.
Viewed: 551 times.
|
| Picture of the stern looking sternwards. You can see in the left side of the picture that I've already started cutting the "structure" away.
Viewed: 519 times.
|
| And the "structure" is completely removed. I've ground the edge joint into a "scarf" to increase the binding surface for the new fiberglass.
Viewed: 533 times.
|
|
1 
